Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAULTS
Fault table
SYMPTOM
There is a smell
of gas near the
appliance.
A burner does not
ignite.
1
2
1
2
The burner does
not burn evenly.
Burner extinguishes
after igniting.
If your gas hob does not work properly it does not always mean that it
is defect. Try to solve the problem yourself first by checking the points
in the table below or check the 'www.pelgrimservice.nl ' website for
more information.
POSSIBLE CAUSE
The appliance connection
is leaking.
Plug not in socket.
Fuse defective/fuse
switched off in fuse box.
Spark plug (1) dirty/damp.
Burner parts not placed
correctly.
Burner parts dirty/damp.
Main gas supply valve
closed.
Fault in gas mains.
Gas bottle or tank is empty.
Wrong type of gas used.
urner parts not placed
B
correctly.
Burner parts dirty/damp.
Wrong type of gas used.
The control knob has not
been pressed long and/
or deep enough (at least
3 seconds).
Thermocouple (2) is dirty.
SOLUTION
Turn off the main gas supply valve. Contact
your installer.
Put the plug into the socket.
Replace the fuse or switch on the fuse in the
fuse box.
Clean/dry the spark plug.
Use the centring leads to put the burner
parts together.
Clean/dry the burner parts. Make sure that
the outflow holes are open.
Open the main gas valve.
Consult you gas supplier.
Connect a new gas bottle or have the tank
refilled.
Check whether the gas used is suitable for
the appliance. Contact your installer if it is
not correct.
Use the centring leads to put the burner
parts together.
Clean/dry the burner parts. Make sure that
the outflow holes are open.
Check whether the gas used is suitable for
the appliance. Contact your installer if it is
not correct.
Keep the control knob fully pressed for
at least 3 seconds between high and low
settings. This can take longer the first time
because of the gas supply.
Clean/dry thermocouple.
EN 7
Advertenties
Inhoudsopgave
