Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1.
Make sure both water stop plugs are in the
indoor unit reservoir (Figure 17, pos. 1 and 2).
2.
Make sure the outdoor unit is placed outside
and the water can be discharged safely.
When choosing caravan mode:
•
The caravan mode indicator will light up (Figure 4, pos. 5).
•
The current ambient temperature will be displayed (Figure 4, pos. 3).
•
The fans starts.
•
For 5 minutes the 'C' will be flashing on the display, indicating the compressor protection
function is active.
•
After 5 minutes: if the SET temperature (preset SET temperature is 21 °C) is lower than
the ambient temperature the device will start cooling.
Choosing home mode
1.
The water-tank indicator will start flashing
(Figure 4, pos. 2) and 'CO' will be displayed.
The following needs to be done:
2.
The condensed water drainage hose
(Figure 14, pos. 2) must be connected to the
back of the indoor unit and be guided into a
bucket (Figure 14, pos. 3).
3.
The adapter (Figure 15, pos. 1) and the heat
exhaust hose (Figure 15, pos. 2) need to be
connected to the side of the outdoor unit.
4.
The water stop plug on the bottom of the
indoor unit needs to be plugged in
(Figure 18, pos. 2).
5.
Press the '+' and '-' button at the same time for 3 seconds to confirm the condensed
water drainage hose and the heat exhaust hose are mounted.
6.
The fans start working.
•
For 5 minutes the 'C' will be flashing on the display, indicating the compressor protection
function is active.
•
After 5 minutes: if the SET temperature (preset SET temperature is 21 °C) is lower than
the ambient temperature the device will start cooling.
32
Figure 17
Figure 18
Advertenties
Inhoudsopgave
