Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
(20) Effect loudspeaker output SURROUND
A mono loudspeaker surround signal (effect signal) is applied to this effect output when pressing the
SURROUND switch (10).
Here you can connect additional passive loudspeakers. These loudspeakers can be used as rear loudspea-
kers to achieve a better spatial playback effect.
The white cinch socket of the amplifier is connected with the left, rear loudspeaker.
The red cinch socket of the amplifier is connected with the right, rear loudspeaker.
The rear speakers are switched in series.
This is why the surround outputs only work when both rear speakers are connected.
The minimum impedance per rear speaker is 4 Ohm per speaker.
The rear speakers carry an effect signal that strongly differs from the „normal" speaker signal
with respect to volume and sound. The surround effect depends on the stereo input signal of the
amplifier.
Cinch socket assignment:
c) Connecting the power supply
The mains outlet must be easily accessible to quickly separate the device from the mains vol-
tage in case of an error. The amplifier's mains switch POWER (2) must be switched off.
The mains outlet must be easily accessible to quickly separate the device from the mains vol-
tage in case of an error.
• Connect the mains plug of the amplifier's mains cable to a socket (230 V/50 Hz) linked to the public power
supply network.
29
Advertenties
Hoofdstukken
Inhoudsopgave
