PRODUCT DIAGRAM
Chain
Heater
Element
Switch
Box
OPERATING INSTRUCTIONS
Place the heater on a firm, level ceiling surface;
The Ceiling hook must be suitably strong and be able to hold a minimum weight of 8 Kg.
Place the Hook A around the Ceiling Hook and clip on any Ring of the Chain to adjust the height of the Patio Heater to the
Floor.
The distance between the bottom of the Patio Heater to the Floor must be over 6.0 feet.
Plug the Patio Heater into a grounded 220~240V 50Hz power outlet.
Only operate the heater when it is in the upright position.
Our Electric Patio Heater is equipped with three heat settings
The switch on the heater head is used to control the three heat setting. (I) for 900w – (II) for 1200w – (I & II) for 2100W, The 0
position is off.
To operate the heater on high, pull the Switch Cord again. This will cause both the bottom and top heating elements to glow
and radiate heat.
MAINTENANCE
Unplug the unit and let it cool completely.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary.
After cleaning, dry the unit with a soft cloth.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deterioration to the surface of the heater.
Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
Wait until the unit is completely dry before use.
STORAGE
Ensure the unit is completely cold before storing in a cool, dry location.
To prevent dust and dirt to build-up, use the original packaging to repack the unit.
CHOKING HAZARD: Store out of reach of children and pets. Contains small parts.
DISPOSAL
DO NOT dispose of via your weekly household waste collection service. ONLY dispose of this product at your local, licensed
recycling/waste centre.
For further information on the disposal of electrical goods, please contact your local authority.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of service:
Check if the power cord is plugged into an electrical outlet, if not,plug in.
Check if electricity to the main fuse is working.
Make certain the power switches are turned on. If not, choose a setting.
ENSURE YOU HAVE READ THESE INSTRUCTIONS THOROUGHLY PRIOR TO USE
Heater
Cover
Mesh
www.sunred.nl