Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FN-120952
PARTS DESCRIPTION
1. Fan guard
2. Fan blade
3. Motor
4. Oscillation knob
5. Speed switch
6. Height adjustment pipe
7. Fastening knob
8. Tripod holder
9. Tripod leg
10. Butterfly fastening screw
11. Metal link pipe
ASSEMBLING INSTRUCTIONS
** Please assemble correctly by the following orders when using.
1. Tripod leg assembly
1) Remove the securing screws and nuts from the tripod holder.
2) Attach the metal part of the wooden tripod leg to the tripod holder, line up the holes and fit the securing
screws all the way through. Take note of the orientation of the leg end.
3) Fit the nut to the protruding end of the screw and tighten the nut.
4) Repeat for the other two legs.
5) Take the butterfly fastening screws out from the small bag.
6) Open out the legs, connect the three metal link pipes by the butterfly fastening screws.
7) Adjust the height adjustment pipe to your desired height and tighten the fastening knob.
2. Motor housing assembly
1) Stand the Tripod on the floor.
2) Remove the big black knob (3) and mounting bolt (2) from the top of the adjustment pipe. Unscrew the knob
and pull the bolt straight out.
3) Loosen the small screw (1) and small black knob (4) from the bracket on the motor housing.
4) Sit the motor housing on top of the adjustment pipe, insert the mounting bolt (2) through the bracket and
the pipe. Note: the Square section under the head of the bolt must be aligned with the square hole in the
bracket.
5) Pay attention to screws' position according to the below picture. Tighten the small screw (1) into position and
screw in the small black knob (4) but do not tighten. Then, fit the big black knob (3) to the mounting bolt (2).
- 4 -
EN
Advertenties
Inhoudsopgave
