Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
d) Switching the device on and off
• To switch on the endoscope basic device, briefly push the on/off button (A4).
About one second later, the device will start and first show a white and then a blue screen.
When starting is completed, the device is in preview mode. This means that the
current camera picture, the set date and the time (D6), as well as the recording mode
for photographs (D3) are shown.
At the upper right of the display, you will also see the display for the battery charge (D1).
If the charge level is too low, change the 4 AA batteries (see chapter 8 a)) before you
continue.
If the symbol for the SD card (D4) is displayed, you either have not inserted a card yet
or the card has not been recognised properly.
• To switch off the endoscope again, briefly push the on/off button (A4) again. Once the display
goes out, the device is off.
e) Setting the camera lighting
To be able to use the endoscope in absolutely dark areas as well, the BS-350XIPSD has an
integrated dial for the LED lighting installed in the camera head. You can set the brightness in
6 levels.
• When the endoscope is switched on, push the button A5 (arrow up) to change the brightness.
• To reduce brightness, push the button A6 (arrow down).
• Set the lighting so that the picture displayed is recognisable well.
In narrow tubes or similar, it may be of advantage to reduce lighting slightly to prevent
reflections and too bright pictures.
39
Advertenties
Hoofdstukken
Inhoudsopgave
