Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
REPLACING OR RE-ADJUSTING
THE BLADES
Please use extreme caution when replacing or re-adjusting the blade, improper
adjustment may result in serious skin irritation or even aggravating cuts.
Switch off the clipper. Undo both screws on the cutting set by using a phillips-
head type screwdriver. Remove the bottom blade and the top blade.
When assembling both blades should be aligned as follows:
1. Set the adjustment lever in the uppermost position.
2. Make sure that the top blade does not extend past the bottom blade.
The distance between the front edge of both blades should be between
0,2 mm – 0,8 mm when taper lever is in the uppermost position.
3. The bottom blade and the top blade should be parallel to each other.
4. The fi rst tooth of the top blade (from the left) must cover the fi rst tooth
of the bottom blade.
5. The outermost tooth of the top blade (on the right) must touch the
outermost large tooth of the bottom blade (on the right).
6 Once the blade is aligned to your liking, gently tighten the two screws on
each side of the blade. If the blade is not adjusted to satisfaction after
testing, repeat the adjusting process.
12
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
