Aan/Uit-Knop; Installing The Power Button With Fingerprint Reader - Dell Latitude 5411 Servicehandleiding
Verberg thumbnails
Zie ook voor Latitude 5411:
- Installatiehandleiding (40 pagina's) ,
- Handleiding (42 pagina's)
Inhoudsopgave
Advertenties
Next steps
1. Install the DC-in.
2. Install the heatsink-UMA.
3. Install the
LED
board.
4. Install the
inner
frame.
5. Install the memory.
6. Install the
WLAN
card.
7. Install the
WWAN
card.
8. Install the
2280 SATA
SSD.
9. Install the battery.
10. Install the
base
cover.
11. Follow the procedure in
Aan/uit-knop
Installing the power button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button with fingerprint and provides a visual representation of the installation procedure.
Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to the palmrest.
Next steps
1. Install the
system
board.
NOTE:
System board can be installed with heatsink attached.
After working inside your
computer.
Demonteren en hermonteren
59
Advertenties
Inhoudsopgave
