Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
With the fan body turned upside down, align the base onto the fan underside, insert, and tighten with
a further 4 screws (C).
Invert the product to the correct orientation, place it on the floor, and check that the product is stable.
•
Ensure all parts are securely attached. Place the appliance in the correct position for use.
Upper water tray:
The upper water tray (lift lid above control panel) is accessible via a hinged cover. Locate and fit the
•
filter cartridge - place in the allocated slot.
Water tank can alternatively be filled / topped up from this location, add water slowly to prevent spillage,
•
shut lid, parts are secure and then place the appliance in the correct.
OPERATING INSTRUCTIONS
Using the Appliance:
Decide on a location for the 3 in 1 tower fan, convenient to a supply socket. It is designed for floor use.
•
Place it on a dry, level surface where it will not overturn during use. If moving the appliance, switch off
and unplug it from the mains.
•
Insert the power plug into an appropriate electrical outlet and switch on power to the outlet.
Switching the Appliance On/Off:
•
Press the ON or OFF button on the control panel once to switch the fan on. The LED display will show
the current ambient temperature.
Cooling:
•
To activate the evaporative cooling function, press the «COOL» button. This will activate the pump,
drawing water from the tank to the upper collection tray. Water will filter internally over the evaporative
inlet filter. The water tank can be filled via the water tank directly or via the upper water tray.
WARNINGS:
Before operation, ensure the water tank has been filled with fresh clean water to at least the minimum
•
level and not beyond the maximum level. Refrigerated water can be used to assist with cooling.
•
Never use water hotter than 30 degrees Celsius.
Maximum tank capacity is 3L; never fill beyond the maximum line.
•
•
The tank cannot be completely removed. Never apply force or try to fully remove it.
Limit movement of the product when the tank is full. Decide on the intended location before filling. If
•
relocation is required, take care to gently move it to avoid water spilling from the tank.
•
Never leave the cooling function on for extended periods with the tank empty; this will cause the pump
to run dry and may result in damage.
Timer:
•
To activate the timer function, press the «TIMER» button. Each subsequent press will step through from
0-12 hours. When the desired time is reached, the LED screen will flash on/off to indicate the selected
time (in hours) and the clock symbol will be activated to indicate the timer has been set. At the end of
the preset period, the fan will automatically switch off.
Speed Selection:
•
To control the fan speed, push the «SPEED» button to cycle between Low, Medium, and High speeds.
Swing/Oscillation of the Outlet Grille:
•
To activate the swing grille function, press the «SWING» button. The outlet air grille will pivot from one
side to the other.
To switch off, press the «SWING» button once when the air is blowing in the desired direction.
•
Hinged Lid
Water Filter (circular)
Upper Water Inlet
Advertenties
Inhoudsopgave
