Before first use
Remove the packaging . Check if all parts are
complete .
NOTE: The product may give off some odour
during first use . These are production or
transport residue that will quickly subside .
Operation
Fold out the stand
7 ]
[
switch on the product, make sure that the
stand
does not touch the curling iron
[
7 ]
Place the product on a heat-resistant, flat
surface and away from other objects .
Connect the mains plug
mains outlet .
Switch on the product by moving the on/
off switch I/0
to I position . The indicator
[
2 ]
light
flashes red to indicate that the
[
6 ]
product is heating up .
As soon as the set temperature is reached, the
indicator light
lights up red continuously .
6 ]
[
Open the clamp
1 ]
[
Clamp the tip of a strand of hair on the
curling iron
.
8 ]
[
Release the clamp
Wind the strand of hair up to approx . 5 cm
above the scalp on the curling iron
not touch your scalp while doing this . (Fig . D)
Hold the strand of hair in place around
the curling iron for approx . 5‒8 seconds
(depending on the hair type) .
Open the clamp
1 ]
[
curling iron
from the curled strand of hair .
[
8 ]
Troubleshooting
Fault
The product is not working . The mains plug
The hair does not get
curled .
10 GB/IE/NI
(Fig . B) . When you
[
8 ]
to a suitable
5 ]
[
(Fig . C) .
.
1 ]
[
. Do
[
8 ]
and carefully pull the
Possible cause
5 ]
[
connected to an mains
outlet .
The mains outlet is
defective .
The product is not yet
heated up .
Wait until your hair has cooled down before
brushing or combing it . Otherwise the result
might not be satisfactory .
If necessary, repeat the above steps until the
result is satisfactory .
After you are finished with styling or when the
product is no longer used, move the on/off
switch I/0
[
2 ]
indicator light
Remove the mains plug
outlet . Allow the product to cool down
completely in a well-ventilated location .
.
NOTES:
The curling iron
touch the curling iron
switched on . Always hold the product by its
handle
.
3 ]
[
Make sure the product is out of reach of pets
or young children during or after use .
Hair must be clean, dry and free from styling
products . This excludes special products that
support curling .
Comb the hair thoroughly before curling .
Use the product in a well-ventilated room .
Automatic switch-off function
The product is fitted with an automatic switch-
off function . After approx . 30 minutes the
product will switch off automatically .
To keep using the product, switch it off and
then wait for 1 second before switching it
back on .
The automatic switch-off function is not
intended as a replacement for switching the
product off properly .
Action
is not
Connect the mains plug
outlet .
Try a different mains outlet .
Wait for a while until the product has
heated up .
to 0 position immediately . The
goes out .
6 ]
[
from the mains
5 ]
[
becomes very hot . Do not
8 ]
[
when the product is
8 ]
[
to an mains
5 ]
[