8
cleaning & maintenance
Before cleaning the refrigerator always unplug the appliance.
Clean the interior of the appliance. Use warm water and a
neutral detergent to prevent any bad smells occurring. After
cleaning, rinse the interior with clean water and rub dry. Leave
the appliance to dry for 1 to 2 hours. Simply remove the shelves,
drawer and door compartments to clean them by hand. Do not
clean the interior accessories in the dishwasher.
Clean the outside of the refrigerator and the gasket with a soft
moist cloth.
We recommend that you dus the back of the appliance with a
cloth or vacuum cleaner once a year in order to maintain a good
output and low energy consumption.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• Remove the lamp cover by unscrewing the screw and pull the
lamp cover towards you.
• First check if the bulb is fully screwed in.
• If the bulb is defective, replace it with a bulb of the same
type: maximum 10 Watt, socket E14. This kind is widely
available.
• Replace the cover and the screw.
• Plug the appliance back into the mains.
KV552-KV601-instructions-0115.indd 17
9
troubleshooting
Problem
Cause
Appliance is not
Appliance is not
functioning; light
plugged in
does not work
Temperature
Thermostat has
inside the
been set
refrigerator is too
incorrectly
high or too low
Air
circulation vents
are blocked
Water is running
Drain outlet is
out of the
blocked
refrigerator
Appliance is ex-
Has the
cessively noisy
appliance been
installed
correctly?
Are the pipes at
the back touch-
ing or vibrating?
The inside light is
Lamp is
not working
defective
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
Solution
Plug the
appliance in the
socket
Set the
thermostat
correctly
Clean the
ventilation
openings
Clear the drain out-
let with a skewer
Check the
installation
Check it and move
the
appliance
forwards
Replace the bulb
following the
instructions
17
English
•
26-1-2015 13:59:49