Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Unit installation
Install the compressor on a level surface in a well-ventilated room with adequate space.
Room temperature should not exceed 35°C.
1. Remove the protectors (without photo).
2. Fix the spraygun holder with the screws on the compressor's top.
3. Pull over the o-ring from the bottom of the moisture trap, into the track
and put the moisture trap into the holder.
4. Screw the short straight air hose onto the air outlet of the compressor and to the air
inlet of the moisture trap.
5. Connect the airbrush and the compressor with the straight air hose.
4
Beginning of operation
Connect the compressor to the power supply system. Turn the on/off switch to I (on). Now the com-
pressor would build up the pressure.
Setting the working pressure
The desired working pressure can be set using the pressure adjustment knob with the airbrush trig-
ger depressed.
1.
Increasing the pressure: Turn the knob in a clockwise direction.
Reducing the pressure: Turn the knob in an anticlockwise direction.
The compressor builds up its highest pressure only with closed adjustment knob.
Note:
12 ENGLISH
3
4
3
5
Advertenties
Inhoudsopgave
