Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY
1.Carefully remove all components from the package and check to ensure
nothing is damaged. If equipment is damaged, immediately notify the retailer
from where the equipment was purchased.
2.The sand filter should be placed on solid, level ground, preferably a concrete
slab. Position the sand filter so the Ports and Control Valve are accessible for
operation, servicing and winterizing.
3.EN60335-2-41 TEST standard requires the sand filter must be vertically fixed
on ground or a certain pedestal made of wood or concrete before use to
prevent the sand filter from accidentally falling. Fully assembled sand filter
will exceed 18 kg. The mounting holes should be 8 mm in diameter and
spaced 86 mm apart. Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
IMPORTANT: Do not place chlorine in the strainer to avoid damaging the sand filter.
LOAD POOL-GRADE FILTER SAND/POLYSPHERE™ POOL FILTRATION BALLS.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately
one 55 kg bag should suffice.
If you do not use the recommended size of filter sand, filtering performance will be reduced and the sand filter may
damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the
Skimmer on the Hub.
NOTE: Sand/Polysphere™ Pool Filtration Balls not included.
NOTE: Use 28 g (0.06 lbs) Polysphere™ Pool Filtration Balls to replace 1 kg (2.20 lbs) sand.
MAX
MIN
MAX
MIN
(You will need a screwdriver.)
7
Φ8
c
c
c
c
c
c
Advertenties
Inhoudsopgave
