Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If necessary, enquire at your local
specialist trade outlet.
WARNING! When drilling
holes, special care should be
taken to ensure that there are no
gas, water or electricity pipes.
To mount the product, you will
need the following tools which
are not included in the package
contents: a pencil, a spirit level, a
suitable screwdriver and a drill.
Two people are required to
mount the product on a wall.
1. Completely remove the hose.
Cut any length of the con-
nection hose (1a) (Fig. B),
which is used to connect the
outside water tap to the wall
hose holder, and connect one
end to a hose connection (3)
(black, no water stop). Tighten
the sleeve (3a) as far as it will
go (Fig. C).
2. Connect this end to the outer
coupling (1b) of the wall hose
holder (Fig. D).
3. Connect the other end to the
hose connection (4) (Fig. E).
Note: Pay attention to the inch
thread of your outside water
tap and use the reducer (4b) if
necessary.
4. Connect this end to the out-
side water tap (Fig. F).
5. Push a hose connection (3)
(black, no water stop) into
one end of the disconnected
hose (Fig. G).
6. Connect the other end of the
hose to the hose connection
(2) (red, with water stop)
(Fig. H).
7. Push the nozzle (5) into the
hose connection (2) (Fig. I).
Note: The nozzle may need to
be turned on to start the flow of
water (Fig. J).
8. Connect the hose connection
(3) to the internal coupling
(1c) of the wall bracket (Fig. K).
Note: Wind the hose up complete-
ly before you start wall mounting.
9. For wall mounting, it is recom-
mended that you assemble
the wall brackets (6)/(7) and
the product. To do so, open
the small wall bracket (7) and
close it after you have hung the
product up on the wall (Fig. M).
10. Hold both wall brackets (6)/
(7) against the wall and mark
the drill holes, drill the screw
holes using a drill and fasten
the wall brackets using the
mounting material (8) (Fig. L).
GB/IE/NI
9
Advertenties
Inhoudsopgave
