Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Building in
Check if the cabinet and the cut-out meet the dimension and ventilation
requirement.
Threat the sawn ends of wooden or synthetic worktops with sealing
varnish if necessary, to prevent moisture causing the worktop to swell.
Lay the hob upside down on the worktop.
Remove the protective layer from the sealing tape and apply the tape
in the groove of the aluminium profile or on the edge of the glass plate.
Do not stick tape round the corners, but cut 4 separate pieces to seal
the corners well.
Turn the hob over and lay it in the recess.
Secure the hob using the fasteners supplied.
In the case of worktops thinner than 35 mm a filler block has to be used
between the fasteners and the worktop. The screws must be screwed
into the pressed holes.
Connect the appliance to the mains. A short beep will be heard and all
the displays will light up briefly. The appliance is ready for use.
Check that it works properly. If the appliance has been wrongly
connected either a beep will sound or nothing will appear in the
displays, depending on the error.
GB 29
Advertenties
Hoofdstukken
Inhoudsopgave
