Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Refilling Water
1. Wait until no steam is being released and there is no pressure in the tank to refill with water. For
protection, the safety valve cannot be opened if there is pressure in the appliance.
2. Operation methods: Push down the steam release button to release any excess steam and
open the safety valve carefully as heat will be released when opening the tank. Refill with water
according to the chapter "PRODUCT USE - Before Use".
3. After filling the water, restart according to the chapter "PRODUCT USE - How to Use".
After Use
1. After the Steam Cleaner is used, unplug the power cord from the mains outlet.
2. Carefully release the steam, until there is no steam left in the tank.
3. Slowly unscrew the safety valve and empty the residual water in the tank.
4. Clean and dry the external surface with a piece of dry cloth.
5. Reinstall the safety valve and tighten it in position.
Problem
The Steam Cleaner does not
power on.
The steam is reduced or
there is no steam being
produced.
36
Possible cause
The device is not plugged in
and switched on.
There is too much water in
the steam output
There is a build-up of li-
mescale.
There is a blocked steam
nozzle/tool.
Solution
Ensure that the device is
plugged into a suitable power
supply.
Decrease the amount of water
in the tank.
Follow the descaling procedure.
Allow the device to cool and
remove the attached nozzle or
tool to check nothing is block-
ing this.
Advertenties
Inhoudsopgave
