Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If you use multi-tablets containing salt and
the hardness of your water is lower than
21dH, you can set the lowest water
softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-
tablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator
starts to flash and the
indicator
comes on with fixed light.
2. Wait until the indicator
the indicator
indicator
continues to flash. The
intermittent flashing of the indicator
refers to the current set level.
• E.g. 5 flashes + pause + 5 flashes =
level5.
3. Press programme button repeatedly to
change the setting. Each time you press
programme button the level number
increases. After level 10 you will start
again from level 1.
4. Press the on/off button to confirm the
setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
goes off and
starts to flash. The
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is deactivated
but it is possible to activate it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator
starts to flash and the
indicator
comes on with fixed light.
2. Press immediately the programme
button.
• The indicator
light.
• The indicator
3. Wait until the indicator
indicator
continues to flash.
• The end indicator indicates the
current setting: End indicator off =
Acoustic signal off.
4. Press the programme button to change
the setting.
• End indicator on = Acoustic signal
on.
5. Press the on/off button confirm the
setting.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
Leonard 41
comes on with fixed
starts to flash.
goes off. The
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
