Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If it is needing to adjust a code (adjust channel) , enter the adjusting code mode. After +/- 20
seconds the IR green light black out exiting the adjusting code. The MUE BAT lights, indicating
entering mute. If there is no need for adjusting the code, short press (1 second) the Power button
entering normal operation.
IR/MUE is red
Short press Power button
Short press (1 second) the Power button, BAT lights only entering normal operation.
Short press Power button
ADJUSTING CODE INSTALLATION
The code can be set only once. The data of a channel is stored forever. The code must be saved
within 20 seconds after turning on the transmitter otherwise the green IR LED turns off and the
transmitter comes into mute mode. Because this system works on two different frequency bands
the code should be twice set for both Channel A and B.
Channel A
Length press (2a3 seconds) the Power button of the receiver and lenth press then the power
button of the transmitter.
Advertenties
Inhoudsopgave
