Advertenties
Beschikbare talen
Beschikbare talen
-
Place the device near a power outlet. Place the device on a flat, solid and stable surface.
Keep at least 50CM free space on all sides and observe the safety instructions.
-
Install the drain hose, and set the window in position well, avoid kinks or bends in the hose,
so that the warm air can be discharged to the outside by means of the enclosed fittings. See
picture below.
-
Turn both ends of the drain hose into the square fixing clip and the flat fixing clip. -
the square fixing clip into openings at the back of the air conditioner.
-
Place the other end of the hose to the nearest window.
-
To dehumidify connect a water hose to the water tap point (number 6). This hose leads into a
collection tray. Please note that the hose must not go up.
-
To cool you to connect a drain hose.
Use
Cooling mode:
-
Press the "Mode" button until the "Cool" icon appears.
-
Press on the UP or DOWN button to select the desired room temperature. (16ºC-35ºC) -
Press the "Fan" button to select wind speed.
Dehumidification:
-
Press the "Mode" button until the "Dehumidification indicator" flashes
-
automatically set the selected temperature in the actual room temperature 2 ° C min.
(16ºC31ºC)
-
automatically adjust the fan motor in a LOW wind speed.
Fan Mode:
-
Press the "Mode" button until the "Fan" icon appears.
-
Press the "Fan Speed" button to select wind speed.
Place
Advertenties
