j) Switch LED Lamps On/Off
The two LED lamps at the side of the vehicle can be swit-
ched on or off with a switch.
The switch is located at the roll-over bar above the speed
controller (see circular mark in the figure on the right) and
can be reached easily from behind.
k) Stopping the Vehicle
To stop driving, proceed as follows:
• Let go of the throttle/brake lever on the transmitter so
that it goes into neutral position, and let the vehicle run
out.
• After the vehicle has stopped, the speed controllers
switch off (switch position „OFF", see figure on the
right).
Never touch the wheels or the drive mechanism, and
make sure you do not move the throttle/brake lever at
the transmitter! Do not hold the vehicle at its wheels!
Attention!
The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!
• Disconnect the drive battery from the speed controller. Disconnect the plug-in connection completely.
• Now you may turn off the transmitter.
45