Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Elektrischer Anschluss
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The WPN 180 and the WPO 180 are made in protection class II.
WPN 180:
For protection purposes, the machine can only be run with a GFCI. For this
reason, the WPN 180 is delivered with a PRCD protective switch integrated
in the cord to connect it with a socket.
The PRCD protective switch must not lay down in water.
!
PRCD protective switches must not be used to switch the
tool on and off.
Before starting your work, check the proper function by
pressing the TEST button
Adjust the contact pressure to the diameter of the grinding attachment and
the driving power of the polisher so that the machine is not overloaded.
Switching on and off
Short-Time Operation
Switching-on:
press on/off switch
Switching off:
release on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off:
press the on/off switch and let it go off again
The Polisher is equipped with an adjusting wheel in order to allow a
continuously variable control of the speed (I – Minimum, IIIIIII – Maximum).
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
By means of a thermal sensor, in case of continuous overload, the motor is
protected against destruction.
automatically and only can be switched on again after a certain cooling
All manuals and user guides at all-guides.com
.
In fact, the machine switches off
14