Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation
1. Connect the power supply
Please decide if you want to power up
Lisa using an USB adapter or batteries.
Do you want to switch the power
supply later? Remove Lisa from the
network and add Lisa again to the
network connected to the right power
supply.
Batteries
•
Remove the back cover of Lisa to place
the batteries: hold Lisa and remove the
back cover by pulling at the bottom of
the opening as shown in the image.
• Make sure the batteries are placed as
indicated in the battery compartment
of Lisa.
• Place the back cover on Lisa.
USB adapter
Do you prefer to use Lisa with the USB
adapter? This is only possible when
using the supplied desk stand to place
Lisa in the room.
• Place the adapter cable into Lisa as
shown in the image. The back cover
does not need to be removed.
• Connect the adapter cable to the USB
adapter and plug the adapter into the
wall socket.
Zone thermostat | 15
Advertenties
Inhoudsopgave
