Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Materials
Mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as carpet
glue residue on the floor .
Sanding plate
Materials
Wood and metal (sanding sheets
wood*, metal*
* depending on the sanding sheet
Application
–
sanding up to edges and hard to reach areas .
Fitting the sanding sheet onto
the sanding plate
♦
Place the sanding sheet
sanding plate
.
Changing tools
NOTE
►
If you wish to use the dust collection, it must be
connected before fitting the tool (see section
"Connecting a dust extraction device") .
WARNING! RISK OF INJURY!
■
Always remove the battery before working on
the power tool .
♦
If necessary, remove an already fitted tool .
To do this, raise the tool release lever
♦
Fit the tool (e .g . the plunge saw blade
the tool fitting .
PAMFW 12 C3
supplied),
centrally on the
.
) onto
NOTE
►
You can fit the tools in any snap position on
the tool fitting .
♦
Fix the tool in place by pushing the tool release
lever
back down again .
■
Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury .
Operation
Switching on and off
Switching on
♦
Push the ON/OFF switch
the appliance on .
The LED work light
ance is switched on to light up the working area
in low light conditions .
NOTE
►
The LED work light
without dust extraction unit
Switching off
♦
Push the ON/OFF switch
switch the appliance off .
Select oscillation speed
♦
Use the speed adjustment wheel
required oscillation speed .
Stage 1: low oscillation speed
Stage 6: high oscillation speed
NOTE
►
The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests .
forwards to switch
lights up when the appli-
may only be used
.
backwards to
to set the
GB │ IE │ NI
│
9
■
Advertenties
Hoofdstukken
Inhoudsopgave
