Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
D
Reassemble empty unit�
Plug into wall outlet, press the Power Button and run a Sterilize Only cycle�
E
F
Empty any remaining solution and rinse with clean water�
Note: Do not use bleach, harsh abrasives or solvents to clean the heating plate,
as they may cause permanent damage and may void the warranty.
Clean Heating Plate
REPLACING THE FILTER
CAUTION: Unplug from outlet and allow to cool for 60 minutes before
replacing filter�
Replace the filter every six months of regular use for optimal performance�
Follow the steps below:
1
The filter is located at the bottom of the base� Gently squeeze the latches on the filter
cover to remove it�
2
Remove and replace the filter, ensuring the pull tab is still visible on top of the filter�
3
Snap the filter cover back into position�
Note: Filter must always be used to ensure proper performance�
4
D
C
B
A
4
6
3
B
A
DESIGN UNITS: MILLIMETERS
TOLERANCES UNLESS NOTED:
NO PLACE:
ONE PLACE:
TWO PLACE:
THREE PLACE:
ANGLE:
ANGLE:
To purchase replacement filters, contact your local distributor�
3
2
2
1
THIS DRAWING AND RELATED 3D CAD DATA
HANDI-CRAFT COMPANY
CONTAINS PROPRIETARY INFORMATION THAT
ARE THE PROPERTY OF
X
2.5
HANDI-CRAFT CO. AND ARE NOT TO BE
.X
0.5
COPIED OR USED WITHOUT THE PERMISSION
.XX
0.25
OF HANDI-CRAFT CO.
.XXX
0.13
X
0.5
2 filters are included�
INTERPET PER ASME Y14.5-1994
DRAWN
.X
0.25
OTHER HANDI-CRAFT ENGINEERING
STANDARDS MAY APPLY
ENG APPR.
THIRD ANGLE
SOLIDWORKS
3D
PROJECTION
MFG/Q.A APPR.
2
DESIGN UNITS: MILLIMETERS
DRAWN
RBW
15JUL19
HANDI-CRAFT COMPANY
TOLERANCES UNLESS NOTED:
ENG APPR.
NO PLACE:
X
2.5
4433 FLYER AVE. ST. LOUIS MO. 63116, USA
ONE PLACE:
.X
0.5
MFG/Q.A APPR.
TWO PLACE:
.XX
0.25
TITLE:
THIS DRAWING AND RELATED 3D CAD DATA
THREE PLACE:
.XXX
0.13
FILTER REPLACEMENT
CONTAINS PROPRIETARY INFORMATION
ANGLE:
X
0.5
THAT ARE THE PROPERTY OF
ANGLE:
.X
0.25
HANDI-CRAFT CO. AND ARE NOT TO BE
COPIED OR USED WITHOUT THE
DO NOT SCALE DRAWING
PERMISSION OF HANDI-CRAFT CO.
INTERPET PER ASME Y14.5-1994
SIZE
C
DWG. NO.
THIRD ANGLE
OTHER HANDI-CRAFT ENGINEERING
STANDARDS MAY APPLY
PROJECTION
MATERIAL
SOLIDWORKS
3D
SCALE: 1:1
2
1
Mineral Deposits
D
C
B
TITLE:
4433 FLYER AVE. ST. LOUIS MO. 63116, USA
MATERIAL
RBW
15JUL19
DO NOT SCALE DRAWING
A
1
REV.
SHEET 1 OF 1
1
B
A
FILTER AND COVER
SIZE
DWG. NO.
REV.
A
1
SCALE: 1:2
SHEET 1 OF 1
1
Advertenties
Inhoudsopgave
