Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
Operation
Sound-to-Light Mode
•
Switch it sound to light control (display Sund).
•
Select the desired option of the selected operating mode.
•
Set the music control sensitivity with the SOUND SENSITIVITY controller. Set this control so that the light effect
changes in time with the music.
Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the controller.
This DMX starting address specifies the first DMX channel to which the effect light responds. The remaining control
channels come after this first DMX channel (DMX starting address).
The effect light requires 4 free DMX channels.
Setting the DMX starting address
•
Press FUNC.
•
Select DMX mode ADDR with the UP and DOWN buttons.
•
Confirm your selection with ENT.
•
Press the button again to set the DMX start address.
•
Select the desired start address A001-A512 with the UP and DOWN buttons.
•
Confirm your selection again with ENT.
The following table provides information about the effects of the settings on the individual DMX channels.
DMX channel
Value
1
000-255
2
000-255
3
000-255
4
000-007
008-190
191-200
201-247
248-255
The display Er-L means that no DMX signal is being received. In this case, check the DMX connection
and the DMX controller.
26
Function
Brightness red
Brightness green
Brightness blue
Lights off
Dimmer 0-100%
Sound-to-light mode
flash effect slow > fast
Continuous light
Advertenties
Hoofdstukken
Inhoudsopgave
