Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Slide the top part of the chimney in the bottom part. Make sure the top part still protrudes from the bottom part by fixing it
temporarily with a piece of tape.
• First mount an exhaust-air pipe on the cooker hood [1] and place both chimney parts on the cooker hood. Pull the exhaust-air
pipe through both parts upwards and connect it to the duct. Fix the bottom part of the chimney to the cooker hood with two
screws 4x8mm [2] and at the top with two screws 4x40mm in the slots. Remove the piece of tape and pull the top part towards
the upper plate. Fix this part on both sides with two screws 4x8mm [3].
1
Check before the first use if all the protective film has been removed.
INSTALLATION OF THE COOKER HOOD FOR RECIRCULATION
When there is no duct to the outside, you don't have to install an exhaust-air pipe on the cooker hood. Install the cooker hood
according to the same steps as before and finally place two carbon filters on the motor.
ELECTRIC CONNECTION
Make sure the supply voltage ratings correspond with those stated on the rating plate. Plug the appliance in. The cooker hood is
provided with a plug. Make sure the plug remains accessible. Place the socket, if necessary, out of sight behind the exhaust-air pipe.
Attention: if you want to make a fixed connection, ensure that a multi-pole switch with a distance between contacts of 3 mm is
installed in the supply cable.
24
•
English
AKB9011-AKB9021-instructions.indd 24
Plate 3
screws
screws
2
Plate 3
3
screws
screws
27-8-2014 9:29:53
Advertenties
Inhoudsopgave
