Download Inhoudsopgave Inhoud Print deze pagina

Installing The Cooker Hood To A Duct - Inventum AKB9011RVS Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

INSTALLING THE COOKER HOOD TO A DUCT

230.0 mm
115.0 mm
Bracket 1
5 - ø 8
AKB9011
• Hold the cooker hood against the wall on a minimum height of 65 cm above the cooker and mark the bottom of the cooker hood
on the wall.
• Measure with a tapeline the actual width of the cooker hood and calculate the middle. For example: 90 cm wide : 2 = 45 cm.
• Do the same with your cooker so you can mount the cooker hood in the center above the cooker. Mark the middle on the wall at
the level of the bottom marking of the cooker hood.
• Determine, using the markings, where the center hole should come for bracket 1.
• Drill with a masonry drill of Ø8mm the middle hole for bracket 1, insert a plug and mount the bracket with one screw.
• Adjust the bracket with a spirit level and mark the holes on the left and right of the bracket 1.
• Remove the bracket and drill the two marked holes. Insert the plugs. Mount the bracket with the screws. Tighten the screws.
• Mount the cooker hood onto the bracket and remove the grease filters. In the exposed interior you will find two holes to properly
mount the cooker hood. Mark these holes on the wall.
• Lift the cooker hood from the bracket and drill the two marked holes and insert two plugs.
• Mount the cooker hood onto the bracket and place the two screws on the inside of the cooker hood in the wall.
• Take the bottom part of the chimney and place on the topside plate 2 with two screws 4x8mm. The plate must be placed on the
inside and mount de screws from the outside.
• Place this part on the cooker hood and mark the drilling holes for the slots of plate 2. Place plate 3 on the desired place on the
wall, in the extension of plate 2. Again, mark the drilling holes for the slots. Make sure the slots in plate 3 are at the bottom
when mounting the plate.
• Take the chimney from the cooker hood, dril the four holes and insert the plugs.
• Mount plate 3 with two screws 4x40mm on the wall.
AKB9011-AKB9021-instructions.indd 23
115.0 mm
X
bottom + middle of the cooker hood
230.0 mm
115.0 mm
Bracket 1
5 - ø 8
AKB9021
2
115.0 mm
X
bottom + middle of the cooker hood
23
English
27-8-2014 9:29:52

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Akb9021rvs

Inhoudsopgave