Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
reversing the door opening
The door of the appliance can be opened on the right or left side. In order to reverse the door opening, please observe
the instructions below. It would be best to do this with two people.
Attention: switch off the thermostat and remove the plug from the socket. Remove all items from the larder,
including the shelves and drawer, before reversing the door opening.
1. Open the door of the appliance and unscrew all fittings,
then remove them from the inside of the appliance.
2. Unscrew the two screws behind the top sheet and
remove it from the appliance.
Then place the top sheet on a soft surface.
3. Remove the two screw of the top hinge.
4. Carefully lift the door and place it on a soft surface
to avoid scratches.
5. Remove the two screws that attach the lower hinge
to the right side of the appliance.
6. Remove the screw from the front leg and move it
to the right side.
7. Place the door on its new location and make sure the pin
goes into the bush at the lower frame section (hole).
8. Refasten the top hinge that you removed earlier on the
left side of the appliance. Make sure the pin goes into
the bush on the lower frame section (hole).
9. Loosely tighten the lower left hinge and only tighten the
bolts when the door is in the correct position and level.
10. Place the appliance upright again, then mount the
top sheet at the front and place it flat on the rear
side. Then place the two screws back at the rear
and fasten them.
11. Open the doors of the appliance and attach all hinges.
Tools you will need:
1.
8mm socket driver
2.
Cross-shaped screwdriver
3.
Putty knife or thin-blade screwdriver
1
Screw
2
Low Hinge
3
Adjustable Low Foot
4
Adjustable High Foot
5
Bovenste scharnier
6
Upper Hinge
7
Shaft Sleeve
8
Screw
9
Cover panel
•
5
Advertenties
Inhoudsopgave
