Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
A.6 Make sure the power cable is disconnected
during the installation.
A.7 If needed, prepare the ground:
• Make sure the surface is level in all directions
• Determine ground level (0 level), which is the
reference point for all other dimensions
• Make sure that the Sutu will be placed
perpendicular to and directly on the prepared
surface
B. DEEP MOUNT
NOTICE
Make sure the necessary preparations
have been made according to chapter A.
B.1 Dig out the holes for the anchors, according to
the indicated dimensions.
B.2 Remove the side panels from the Sutu.
B.3 Lift the Sutu using a forklift and lifting belt.
B.4 Attach the 7 anchors to the Sutu.
B.5 Lower the anchors into the holes. Pull the power
cable through the hole in the bottom of the Sutu.
B.6 Support the Sutu, for example with a beam
construction like in the picture. Level the Sutu in
all directions.
EN
EN
C. SURFACE MOUNT
NL
NOTICE
Make sure the necessary preparations
DE
have been made according to chapter A.
NOTICE
Please note these pictures are from the
back view of the Sutu.
C.1 Remove the 4 side panels from the Sutu.
C.2 Place the Sutu in the right position with
respect to the power cable. Mark the required
position for the holes of the 11 chemical anchors.
D. INSTALLATION
D.1 Connect the power cable to the computer.
WARNING Electric shock risk! Connecting an
electrified power cable to the power socket could
lead to serious injury. Disconnect the power cable
during the installation.
YA3550-210723
A.8 Choose the installation type suitable for the
surface on which the Sutu will be installed.
WARNING A surface mount can only be done
when the existing surface is made of at least 15
cm (5.9") solid concrete.
• Deep mount (in existing ground - anchors):
continue with part B
• Surface mount (on top of existing surface -
cable slots): continue with part C
B.7 Pour the concrete at least to the indicated
height and wait until it has hardened.
NOTICE
If you are installing a Sutu with sports
boarding (Sutu M/L/XL/Plaza), place the Sutu at a
height of 20mm [0.8"] to level with the boarding
system. The concrete should not be poured yet, but
after finishing the boarding. Please continue the
installation at step D.1.
B.8 Remove the wooden packaging beams. Fill the
remaining cavities with sand.
NOTICE
You can now continue installing the Sutu
from step D.1.
C.3 Move the Sutu away. Drill 11 holes according to
the indicated dimensions. Mind the use of different
drill bits when placing different types of chemical
anchors.
C.4 Place the Sutu back in position. Fix the Sutu to
the ground using the chemical anchors according
their instructions.
WARNING Installation should be done by a
certified installer according to local regulations on
electrical safety (e.g. NEN 1010).
D.2 Remove the crane hooks from the Sutu.
34
Advertenties
Inhoudsopgave
