Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
coNNEctINg to tHE WAtER tAP AND DRAINAgE
Make sure that the indoor plumbing is suitable for installing a dishwasher. Also, we
recommend that you fit a filter at the beginning of the water supply in your house to
avoid any damage to your appliance because of any contamination (sand, clay, rust, etc.)
that might occasionally carried in through the mains water supply.
• Always use the new water inlet hose supplied with your appliance. If you are using the
new water inlet hose, run water through it for a while before making the connection.
• Connect the water inlet hose directly to to the water inlet tap. The pressure supplied by
the tap should be at a minimum of 0,03 Mpa and at a maximum of 1 Mpa. If the water
pressure is above 1 Mpa, a pressure-relief valve should be fitted inbetween.
• After the connections are made, the tap should be turned on fully and checked for
water leakage.
• The appliance is supplied with an double-walled aquastop. The system
automatically cuts off the water supply if the water inlet hose starts to leak
and the space between the walls is filled with water. Make sure not to cut into
the aquastop or that it gets twisted or stuck.
• The water drain hose can be connected either directly to a drain pipe with a
minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or
crimping it. The free end of the hose must be at a height between 40 and 100 cm and
must not be immersed in water.
• Close the water tap after each use.
Warning: When a drain hose longer than 4 m is used, the dishes might remain dirty. In
that case Inventum will not accept responsibility.
35
Advertenties
Hoofdstukken
Inhoudsopgave
