Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
NOTES:
a) The measurement markings on side of the blade guard (6) can be used as a guide in setting the
depth of cut. The measurement mark on the guard that intersects with the edge of the blade indi-
cates roughly the depth of cut.
b) Always set the cutting depth 1/8" greater than the thickness of the workpiece.
c) Always test the depth setting on a scrap workpiece to verify the setting before cutting into the good
workpiece.
INSTALL EDGE GUIDE MOUNT (see Fig. 7a)
1.
Insert the edge guide dovetail (1) into the matching slot
(2) in the front of the blade guard.
2.
Slide the edge guide mount toward the right hand side of
the blade guard until the mounting screw (3) lines up with
the matching threaded hole (4) in the blade guard.
3.
Carefully turn the mounting screw clockwise into the threa-
ded hole until it holds the edge guide firmly in place.
4. Tighten the mounting screw using a 5 mm hex key. NOTE:
Do not over tighten the mounting screw. You will break the blade guard.
INSTALL EDGE GUIDE (see Fig. 7b)
The multi-cutter can be used with an edge guide for ripping
materials up to 6" wide.
1.
Turn two edge guide locking screws (1) counter clockwise
a few turns until the screws rise about 1/8".
2.
Insert edge guard rod (2) into the edge guide mounting
block slot (3).
3.
Slide edge guard toward the tool until the desired width
of cut is indicated on the scale (4) where it meets the edge
of the edge guide mounting block.
4. Tighten both edge guide locking screws.
NOTES:
a) Do not over tighten the edge guide locking screws or you
will break the edge guide mounting block.
b) The edge guide scale is only an approximate measurement. Always check the width of cut on a scrap
workpiece.
ON/OFF SWITCH (see Fig. 8)
This tool has dual purpose ON/OFF switch that is designed to prevent ac-
cidental starting of the tool. It also automatically turns the tool OFF then
the switch is not held in the ON position.
1.
Press the center of the switch (1) inward.
2.
While holding the center of the switch inward, slide the switch but-
ton (2) forward until the tool starts.
3.
To stop the tool, release the switch button. It will automatically turn
the tool OFF.
12
|
2
1
2
4
1
2
Fig. 7a
3
1
4
3
Fig. 7b
Fig. 8
Advertenties
Inhoudsopgave
