Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
the inside of the freezer and the accessories dry.
Remove the melt water gutter, turn it 180o again and replace it.
•
Close the freezer door and turn on.
•
CLEAN THE FREEZER REGULARLY.
Note: before cleaning the cooling device and its rear compartment part,
the device must be disconnected from the mains by unplugging.
Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In
•
case of accidental spills – immediately clean with warm soapy water or dishwashing
detergent. Wipe dry.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
At least once a year clean dust away from the back part of the appliance body and the
•
compressor.
A soft brush, electrostatic cloth or vacuum cleaner may be used for
cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for
•
cleaning the appliance inner and outer surfaces. DO NOT use for cleaning cloths or
sponges that have coarse surfaces intended for scrubbingIf the appliance is to be left
switched off for an extended period, leave its doors open.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors YOU CAN NOT lay the refrigerator
horizontally!
Before you get started, please note the following:
∙ Always ensure that the correct number of washers are used on the hinge bolts.
∙ To ensure that the door can close tightly against the frame, take the utmost care that it
is properly aligned during reassembly.
Do the actions below in the order they are listed (see fig. 6, page 2):
W A RN I N G ! Turn off the freezer and pull the plug out of the electricity supply outlet.
1. Remove covers c from the inside of the housing and door and the upper bracket 6
together with the nut and washers and the gasket under the bracket.
2. Remove the freezer door 1. Remove the stop plate from the bottom 2. Screw the stop
plate (included in the package) on the opposite side of the door to open the door to the
left.
3. Remove the bottom cover 3 together with the small cover 4.
4. Unscrew the shaft 5 together with the washers on the shaft and the catch 8 from the
lower bracket 6 and screw them to the bracket 7 on the other side of the cabinet
symmetrically to the former position.
5. Push the freezer door onto the bracket 7 on the newly installed shaft 5.
Remove food from the freezer compartment. The frozen
•
foodstuffs will not warm up too much while you are thawing
the freezer compartment if you cover them with a thick cloth
and keep them in a cool place.
Pull out the melt water gutter, turn it 180° and hook it up.
•
After thawing, place the container with the water gutter.
Leave the freezer door open. After the frost has thawed, dry
•
9
Advertenties
Inhoudsopgave
