RUNNING BOARD/BELT MAINTENANCE
RUNNING BOARD/BELT MAINTENANCE
The treadmill running belt has been pre-lubricated prior to leaving the factory.
With use the running belt will move to the left or right and become loose. In order to
protect your investment and prolong the life of your treadmill it's important to know how
to lubricate, tighten and align the running belt correctly.
For this reason, refer to the instructions below.
RUNNING BOARD/BELT LUBRICATION
Lubricating under the running belt will ensure superior performance and extend its life
expectancy. After the fi rst 25 hours of use (or 2-3 months) apply some lubricant, and
repeat for every following 50 hours of use (or 5-8 months).
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck. If the surface
is slick to the touch, then no further lubrication is required. If the surface is dry to the
touch, apply some lubricant.
How to apply lubricant
Lift one side of running belt.
Pour some lubricant under the centre of the running belt on the top surface of the
running deck. Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute
lubricant.
NOTE: DO NOT over lubricate running deck. Any excess lubricant that comes out should
be wiped off.
2021-04-19 OCG BluMill Treadmill + Bluetooth ManualV02.indd 11
2021-04-19 OCG BluMill Treadmill + Bluetooth ManualV02.indd 11
EN
11
07-12-2021 14:46
07-12-2021 14:46