Inhoudsopgave
Advertenties
a) Wireless method
Set the SmartLoader to "Wireless" mode using the side switch.
Turn on the TV, and while holding the SmartLoader, point it in the direction of the
TV. Press the "MENU" Key on the SmartLoader.
b) Wired method
Connect the SmartLoader to the TV using the appropriate accessory cable.
Set the SmartLoader to "Wired" mode using the side switch.
Turn on the TV, and while holding the SmartLoader, point it in the direction of the
TV. Press the "MENU" Key on the SmartLoader.
On the TV screen, highlight the menu option "SMARTLOADER TO TV"
Press the right arrow key on the SmartLoader to initiate the copying process
> A number display (from 0~100) will be shown on screen, indicating the percentage of the installation
progress from the SmartLoader to the TV. When the data transfer is completed, "##" will show "100" and
the message GOODBYE will appear.
The TV will go to Standby mode. When the TV is next powered on, it will be configured with the settings
>
from the Master TV, and ready for use.
Problems and Solutions:
The message "I2C ERROR" is displayed on the screen.
1.
Bad connection of RJ11 wire or wrong data transmission has occurred. Try again.
The message "WRONG VERSION" is displayed on the screen.
2.
The program contained in the SmartLoader has a software code incompatible with the actual TV.
Reprogram the Wireless SmartLoader from a Master TV whose software code is compatible with the
actual TV.
TV doesn't respond to the SmartLoader.
3.
Check if the LED on the SmartLoader lights up in green when pressing any button.
If the LED is red, it means that the batteries are low and should be replaced.
Bring the SmartLoader closer to the TV infrared receiver and try again.
Notes:
Make sure that the 3 R6/AA sized batteries are placed correctly in the bottom compartment of the
SmartLoader. The LED on the SmartLoader should light up in green when pressing any button, indicating
operational batteries. When the LED shows red, the batteries need to be replaced.
The SmartLoader can only copy the settings between 2 TVs of the same type. Once the
SmartLoader is programmed with the settings from a Master TV of a certain type or model,
then these settings can be installed on another TV of the same model only.
The SmartLoader cannot be used to copy the (digital) channel table of a Digital TV set.
If the SmartLoader is used with a DVB (European Digital) TV set, then the TV set must first
be switched to Analog mode.
SMARTLOADER TO TV ## (0-100)
- 7 -
Advertenties
Hoofdstukken
Inhoudsopgave
