Inhoudsopgave
Advertenties
The Philips SmartLoader works in 2 modes – Wireless and Wired:
Wireless mode ---- through infrared sensor (15/20HF5234)
Switch the SmartLoader to "Wireless" mode by sliding the side-switch to the
device. Point the Wireless SmartLoader to the TV's infrared receiver (optimal distance of 5-30cm) and proceed
with the Installation procedure listed below.
Wired mode ---- using the by-packed accessory cable(s) (20/26/32HF5335D)
Switch the SmartLoader to "Wired" mode by sliding the side-switch to the
device.
Examine the rear connectors of the TV set to determine if the 3-pin or 4-pin female connector wire (packed
with the Wireless SmartLoader) should be used. Plug in the correct connector wire to the corresponding
opening on the TV set (usually marked as SERV C), and then connect the RJ11 jack end of the accessory wire
to the RJ11 socket on the SmartLoader.
The Installation Procedure consists of three simple steps:
1. Choosing a Master TV
The Master TV is the TV set whose installation and configuration settings are to be copied into other TV's (of
the same type only).
2. Programming the SmartLoader with the settings from the Master TV
Follow these steps to program the SmartLoader with the settings of the Master TV.
a) Wireless method
Set the SmartLoader to "Wireless" mode using the side switch.
Turn on the TV, and while holding the SmartLoader, point it in the direction of the
TV. Press the "MENU" Key on the SmartLoader.
b) Wired method
Connect the SmartLoader to the TV using the appropriate accessory cable.
Set the SmartLoader to "Wired" mode using the side switch.
Turn on the TV, and while holding the SmartLoader, point it in the direction of the
TV. Press the "MENU" Key on the SmartLoader.
The Master TV will show the following menu:
On the TV screen, highlight the menu option "TV TO SMARTLOADER"
Press the right arrow key on the SmartLoader to start the programming process
A number display (from 0~100) will be shown on screen, indicating the percentage of the programming
progress from the TV to the SmartLoader. When the programming is completed, "##" will show "100" and the
message "DONE" will appear.
TV TO SMARTLOADER ## (0-100)
The SmartLoader is programmed and can be used to install and configure other TVs.
Copying the settings of the Master TV to other TVs with the SmartLoader
Follow these steps to install and configure the settings of a Philips TV with the SmartLoader.
SMARTLOADER TO TV >
TV TO SMARTLOADER >
icon on the SmartLoader
icon on the SmartLoader
- 6 -
Advertenties
Hoofdstukken
Inhoudsopgave
