∙ Always ensure that the door is properly closed and that the
seal is not obstructed by bottles stored inside the cabinet.
∙ Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes before it
switches on again.
∙ Note: In position '0', the cooling function is switched
off, though the appliance is still connected to the mains.
Interior lighting
∙ The interior light can be switched on by means of the
separate On/Off switch.
∙ Caution: do not remove the cover of the interior LED
light. If there should be any malfunction, please contact the
customer service for assistance.
Storing wine
∙ The following temperatures are suitable for various wines:
Red:
Dry/white:
Sparkling/champagne: 5 - 9 °C
Cleaning and care
Always remove the plug from the wall socket before
cleaning.
During operation, you may notice a build-up of frost around the
integral evaporator sealed into the rear of the inside cabinet.
This layer of frost will start melting when the compressor is not
working. Through a system of hoses, the melt-water drains
into the collection tray below the compressor, where it will be
absorbed into the surrounding air.
The unit does not therefore require de-frosting, but only proper
cleaning.
∙ To enable the melt-water to drain freely, always ensure that
the channel and discharge opening in the cabinet are free of
any blockage.
∙ Any water collecting in the bottom should be removed.
Remark: Do not use abrasive tools, materials containing
alcohol or harsh cleaning solutions. Do not use any electrical
appliances, such as steam cleaners, for de-frosting or cleaning.
∙ Do not pour water over or inside the unit.
∙ The cabinet should be cleaned once a month.
∙ For frequent cleaning we recommend the use of a damp
cloth and a little mild detergent.
∙ Any accessories should be cleaned separately with soapy
water. Do not put them in a dishwasher.
∙ After cleaning, all surfaces must be wiped completely dry.
When re-inserting the plug into the wall socket ensure that
you have dry hands.
∙ To save energy and to ensure optimum performance, the
compressor (at the rear) should be carefully cleaned at least
twice a year, with a brush or a vacuum cleaner.
910070 de-en-fr-nl ma 2019
15 -18 °C
10 -15 °C
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are caused by:
∙ the electric motor
within the compressor
assembly; during
compressor start-up
the sound level will be
slightly higher for a short
time.
∙ the cooling agent
owing through the circuit.
In addition, the side of the housing may become warm. This
heat is caused by dissipation of the heat generated inside the
cabinet.
The following table lists possible malfunctions, their probable
causes and solutions. In the event of operational problems,
check rst whether a solution can be found using this table. If
the problem persists, disconnect the appliance from the mains
power and contact our Customer Service Department.
12/26