Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4.
Connecting the cable
-
Indoor unit
Connect the power cable to the indoor unit by connecting
the cables to the units to the clamps on the terminal board
in the correct sequence. The colours of the wires and the
reference on the clamps must correspond.
Note: In some models, the cover must be removed in order
to connect the wiring.
-
Outdoor unit
1.
Remove the access cover of the unit by loosening the
screw. Connect the wires to the clamps on the terminal
board in the following manner:
2.
Connect the power cable to the terminal board.
3.
Replace the cover and tighten the screw.
The illustrations are based on standard models.
The air conditioner you have purchased may be a different model.
Warning:
1.
Always connect the air conditioner to a separate power circuit. Refer to the diagram on the inside of
the access cover for the connection of the wires.
2.
Check that the cable thickness conforms to regulations (see table below).
3.
Check that all wiring is securely connected.
4.
Install an earth leak switch.
Note: All cables used must be approved in accordance with local regulations.
Cable specifications
Type
TS27
Power cable
Power cable connection
Cross-section
Type
Front panel
Indoor unit
Outdoor unit
Power cable connection 1 (heat pump)
Cross-section
Type
Terminal board
(inside)
Base plate
Housing
Access cover for
terminal board
(inside)
Cross-section
4
11
Advertenties
Hoofdstukken
Inhoudsopgave
