Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7.3 Replacing blades
Tip: Remove the sparkplug cap before replacing blades.
1) Ensure that the machine is steady and level. Set the blade angle so that the blades level
with the concrete surface.
2) Undo the 2 bolts and washers that secure each blade to the trowel arms using a spanner
or socket (LTM 600 - 10 mm). Remove all blades in this way.
3) Before mounting the new blades, remove any concrete residue from the bottom and sides
of the trowel arms.
4) Mount the new blades. If you are using combination blades, you must ensure that the right-
hand side of the combination blade is behind the trowel arm. This means that the rounded
side of the combination blade must face towards the turning direction of the machine
(clockwise, to the right).
5) Replace the 2 bolts and washers on each trowel arm and tighten the bolts.
8. Disassembly, disposal
Local environmental regulations must be observed (separate discharge of polluting
substances).
Recommendation to the protection of the environment. An old machine contains valuable
materials. A discarded machine and any accessories you can bring it to the nearest waste
collection site.
Construction materials
The machine has been produced with the following materials:
LOCATION
Engine housing
Gearbox
Gears
Stabiliser Ring
Misc. Parts (small)
Trowel blades
Safety switch
Drive belt guard
Drive belt / hand Grips
Operating handle
Drive shaft
Table 3: Used construction materials.
26/58
Gebruikershandleiding / User Manual / Bedienungsanleitung LTM600B/LTM600ER, rev. 1.5: 24-10-2018
MATERIAL
Aluminium
Aluminium
Bronze / steel
Aluminium
Steel
Steel
Nylon 6
Synthetic
Rubber
Steel
Steel
Advertenties
Inhoudsopgave
