Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MAINTENANCE
Grease filters
Carbon filter
Lighting
EN 8
Removing the grease filters
Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Open the panel and pull the special
handle to remove the filter.
Replacing the carbon filter
The carbon filter must always be used if the cooker hood is not ducted.
1. Remove the grease filters.
2. Fit the carbon filter.
3. Fit the grease filters.
Note:
• Saturation of the activated charcoal will eventually occur after more
or less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• In all cases it is necessary to replace the cartridge at least every
four months.
• DO NOT wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly, change the filter regularly.
Activating the alarm signal
• In recirculation version hoods, the filter saturation alarm must be
activated on installation or at a later date.
• Turn the lights and the motor off.
• Press 'D' and hold for approximately 5 Seconds:
I
- The display shows 'FC' and the indication on the bottom right flashes
twice. The filter saturation alarm is ACTIVATED
- The display shows 'FC' and the indication on the bottom right flashes
once. The filter saturation alarm is DEACTIVATED
Faulty LEDs must be replaced by a professional installer.
Advertenties
Hoofdstukken
Inhoudsopgave
