Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
IE
NI
Measuring
1. Select the required
mode.
2. Press the "Laser" button
(4) to measure.
3. Aim the laser at the
point to which you want
to measure the distance.
4. Press the "Laser" button
(4) again.
The measured value is
now displayed.
Error codes
Error 08 - Pythagorean
theorem cannot be used, no
right-angled triangle
Error 10 - Battery empty
Error 15 - Value is outside
the measuring range
Error 00/44 - Distance to
be measured is too close
Belt clip
During breaks in work, the
device can be hung from
a belt, using the integrated
belt clip (5). Ensure that the
device is switched off.
10
Charging the
battery
Do not expose the
battery to extreme
conditions such as heat and
shocks. There is a risk of
injury caused by leaking
electrolyte solution! In the
case of contact, rinse with
water or neutraliser. Seek
medical advice if the
solution has come into
contact with the eyes etc.
The battery must only
be charged up in dry
areas.
• Charge the built-in battery
before using it for the fi rst
time.
• Defects resulting from
improper handling are
not covered by the
warranty.
• The battery is not
replaceable. If you have
any problems with the
battery, please contact
the service centre.
1. Insert the USB-C plug (9)
into the charging socket
(6) on the device.
2. Connect the USB plug
(8) to a USB port/power
supply. The supply
voltage / charging
voltage must not be
Advertenties
Hoofdstukken
Inhoudsopgave
