Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TROUBLE SHOOTING
1.
If the power supply indicator is off and the laser doesn't work, please check the
power supply and the input voltage.
2.
In Stand-Alone operation, if the power supply indicator is ON and sound active
indicator is OFF, but the laser doesn't work.
A.
Because sound is too small and cannot activate laser running, please
increase the music volume or increase audio sensitivity on rear panel.
B.
Please check if unit has been set up in slave mode, or DMX mode.
3.
In Master-Slave operation, slave units don't function, please check as below.
A.
Make sure there's only one master in the chain, and the others are set in
slave mode.
B.
Make sure to control the units with DMX controller.
C. Make sure to use a good quality power cable and XLR connector.
4.
If the output beam direction above is unusual, please restart the unit.
5.
If the unit is fail, please turn off the unit, and then turn on again after 5 minutes.
After trying the above solution you still cannot sort out the problem, please
contact your dealer or our company for service.
Advertenties
Inhoudsopgave
