Inhoudsopgave
Advertenties
GB
2. INSTALLATION INSTRUCTIONS
Install the Starline Roldeck control RD 2013, protected from moisture in accordance with its
protection class, in a well-ventilated (technical) space.
Mount the RD 2013 on a flat wall, using the attachment holes meant for this purpose.
These holes are on the bottom left and bottom right and in the centre top. Leave a minimum of 5
cm space around the RD 2013.
Do not install the RD 2013 above chemicals or in a space where chemicals are stored.
This can seriously damage PC board and components, and as a result of this the guarantee will
lapse.
Electrical connection and adjustment and servicing work may only be carried out by a certified
electro technician!
The connection diagram and the prevailing safety regulations must be taken into account.
It is preferable for the 230 Volt connection of the RD 2013 to be connected over the Starline Pool
control. If this is not possible, the RD 2013 can be connected directly to the 230V mains voltage
which has an earth leakage circuit breaker with a IFN value of ≤ 30mA.
3. SAFETY INSTRUCTIONS
Switch the key switch to "0" and remove the key when the Roldeck is not in use.
Have the Roldeck installation inspected once a year by your installer.
You should report any malfunctions in the Roldeck to your installer.
Important:
Read the installation instructions en safety instructions before installing and operating
the roldeck control.
PLEASE NOTE:
Before the housing is opened the equipment must be switched off*.
PLEASE NOTE:
The Roldeck must not be (partially) closed or opened if there are people in the
swimming pool.
Always switch the key switch to "0" when the Roldeck is open and there are people
in the swimming pool
RDEB2013MM.04
5
Advertenties
Inhoudsopgave
