Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ALARM TEST
1
Briefly press the test button in the
centre and release
2
The unit will give an audible alarm
consisting of 2 cycles of 3 loud beeps,
then stop automatically
3
The red LED on the alarm will flash
rapidly during the audible signal
As with all electronic alarm products you
should test your heat alarm every week
WARNING:
The
provides a full test of the alarms functionality
DO NOT try to test the alarm with a naked
flame, as this might present a fire hazard in
itself
MAINTENANCE
Vacuum every three months to help keep the
unit working efficiently. Vacuum the exterior.
Prevent vacuum from touching the unit
WARNING: Never attempt to open the
battery cover
electronic
test
button
TROUBLESHOOTING
If your heat alarm chirps intermittently:
• Check the location of your alarm
• If the alarm chirps every 45 seconds and
the amber LED flashes at the same time,
this indicates that the power pack is low
Replace the unit within 30 days
If the amber LED is flashing and the alarm is
chirping:
• If the amber LED flashes at a different
time to the chirp, this means there's
a fault with your alarm and it needs
replacing
If your heat alarm does not sound during
testing:
• Push the centre test button firmly.
• If the unit has been silenced and is in low
sensitivity mode, it may not sound Wait
15 minutes
• Make sure the alarm is securely located
into the base plate
If the alarm fails to operate correctly contact
Technical Support on: 0330 094 5830.
5
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
