Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Periodic Condenser Cleaning
Disconnect the electrical outlet from your dispenser and make sure there is no current.
Loosen the screws of the cap with "Radiator (Condenser) Cleaning Warning" on (cover on the left when viewed
from the front of the machine) with a screwdriver. The cover will pop out when you pull the cover down.
Clean the condenser with a brush and a vacuum cleaner.
This maintenance will make your machine run more efficiently and will extend its service life.
Never use sharp tools with the condenser, do not crush the panels.
Troubleshooting
PROBLEM
The dispenser is not working
The dispenser does not cool
The tap constantly drips
Valid for SPRAY Dispensers:
There is no SPRAY function
(7065.0015)
Valid for MIXER and KAM
Dispensers:
There is no Mixing
(7065.0020)
Valid for KAM Dispensers:
Liquid flows from the tap
nozzle
CAUSE
1. The dispenser may not be connected
to electricity.
2. The fuse may be blown.
3. Thermal protector may be off.
4. Thermostats may be off.
1. The condenser may be very
contaminated.
2. Air circulation may not be sufficient
around the dispenser.
1. The tap nozzle may be contaminated.
2. The tap hose o-ring may be torn.
3. The tap hose may not be securely
placed.
4. The tap spring may be hardened.
1. The snail magnet may be inserted
upside down.
2. The pump magnet can be covered
with sugar.
3. Fruit particles may be stuck under
the magnet.
4. The magnet washer may not be in
place.
1. Oil may have accumulated on the
pallet.
2. The mixer pallet magnet might have
been fitted upside down.
3. The pallet may not be installed in
place.
The gaskets of the foaming apparatus
may be deformed or not fully fitted.
www.combisteel.com
SOLUTION
1. Connect the dispenser to the
mains.
2. Check the fuse
3. Wait some time.
4. Turn on the thermostat.
1. Clean the condenser with a
brush.
2. Make sure that there is enough
air flow around the machine.
1. Clean the nozzle.
2. Check the o-ring of the faucet
hose.
3. Be sure that the faucet hose is
securely placed.
4. Check the tap spring and if
needed replace with a new one.
1. Remove the pump and clean.
2. Remove the magnet and clean
3. Press down the pump pin.
4. Put the washer in place.
1. Remove the palette and clean it
with lukewarm water.
2. Re-place the magnet by making
sure that the magnet is facing
down.
3. Re-place the palette.
Ensure that all gaskets of the
foaming apparatus are in place
and not deformed.
11
Advertenties
Inhoudsopgave
Probleemoplossen
