Programming The Remote Control; Learning Additional Transmitters - Becker TimeControl TC445-II Montage- En Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor TimeControl TC445-II:
- Gebruikers- en montagehandleiding (116 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Programming the remote control
1) Learning the master transmitter
a) Put receiver into learn mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Activate the "Learn" key or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
When the receiver is in "Learn" mode, the learn button is to be pressed until
the receiver indicates that the learn process has been successfully completed.
The learn process is now complete.
2) Learning additional transmitters
a) Press the learn button of the master transmitter until acknowledgement is
given by the receiver.
b) Now press the learn button of the new transmitter until acknowledgement is
given by the receiver
c) Then press the learn button of the new transmitter to be learnt once again.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m outside and inside the building and up
to 350 m in the open.
de
en
fr
nl
37
Advertenties
Inhoudsopgave
