Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
eNet radiografische schakel-/pulsactor 8-voudig / jaloezieactor 4-vou
dig, voor DIN-rail
Priority, twilight
Slat change-over time
Fabric-stretching time
Running time
Minimum change-over-time
Invert movement direction
Operating hours up
Operating hours down
Information window
During channel selection in the Information window, the following settings can be made or valu-
es displayed.
Display value / Switching
Operating hours
82581923
J0082581923
0...4
Basic setting: 0
0 ms ... 10 sec
300 ms ... 10 s
Basic setting: 0 ms / 300 ms
1 ... 600 sec
Basic setting: 120 s
300 ms ... 10 sec
Basic setting: 1 s
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
0...65535
Basic setting: Current value
Explanations
Display of the operating hours since the last
restart in the Settings window Einstellungen.
16/17
Specifies the priority for
recalling and removing a sce-
ne of type Twilight for the
channel.
Absolute time for changing-
over Venetian blind slats. The
fabric stretching time can also
be set here for the Awning
operating mode.
Absolute time which the
blind/shutter requires from the
top to the bottom end position.
The entry is essential if scene
or position movements are to
occur.
Minimum interruption time
when changing directions.
Increasing the minimum chan-
ge-over time will cause less
wear on the motors.
Inverts the activation of the
relay outputs. During inverted
operation, the relay outputs
"Up" and "Down" should be
activated in reverse. This is
required, for example, for con-
trolling skylights.
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The
device must be programmed
to apply the change.
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The
device must be programmed
to apply the change.
22.07.2016
Advertenties
Inhoudsopgave
