Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Location and connection
Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Check whether the Main switch is set to OFF (O).
Fully extend the power cord and plug into a suitable 220-240V socket. To
prevent the circuit overloading, check that no other appliances are connected to
the same group.
Set-up and operation
Activate the heater by switching the main switch to I (ON).The display lights up
and shows the ambient temperature. If you
take no further action the light on the
display switches off after 30 seconds.
Push 1 x the ON/OFF and ventilator button.
The ventilator starts and the other
functions can be selected.
Heating. 1 x push = 1000Watt, 2 x push =
2000Watt, 3 x push = back to ventilator
only.
Oscillation. Push to start, and then push
again to switch off.
Timer. Push the button the number of hours after which the heater must switch
itself off (from 0 to 8 hours).
Thermostat buttons. After pushing, "AUTO" is shown in the display. You can now
set the desired temperature, from 15 to 35°C. With '+' you increase the desired
temperature, and with '-' you
decrease the desired temperature.
The display shows the set
temperature for 3 seconds and
then switches back to the ambient
temperature. When the
temperature drops to more than 2°
below the desired temperature the
heater will operate at 1000W.
When it drops to more 3° below
the desired temperature, the heater will operate at 2000W. If the ambient
temperature is higher or equal to the set temperature, the heater will switch off.
Pushing the ON/OFF and ventilator button again simultaneously will switch off
all functions. The ventilator will then cool down for 30 seconds. Then switch the
main switch to 0 and pull the plug out of the socket.
30
Advertenties
Inhoudsopgave
