User manual TWIN500
Before use:
• Load: This system has two complete separate operating systems, two pumps, two tanks and
two batteries. You should charge both batteries and 1 and 2. In paragraph 9, you can clearly
read that the batteries are loaded. For charging you plug in at point 10.
• The piston hangs in the lifting hook (with protection cover). 1
• The switch to "on". 3 The device will detect and pumps. The crane is set to "loose". 2.
• The alert will stop, the pumps are slightly longer than the alert. The device is ready for use.
Ready for use:
• You can place the suction cup to the surface and turn handle 2 to determine.
• Wait until the vacuum gauges 7 (2x) is the alert in the green area and stops.
• It's ready for use now.
When using:
• You can rotate the device to handle 8.
• The device can be tightened to 9, so that you can not tilt the piston by mistake.
• When you note that the pump should be regularly lifted, you should check the rubber edges
well for leaks or cracks.
• Do not lift during the signal.