Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10.3 Removing printed models
1. After printing is completed, remove the magnetic mat from the print bed. See fig. F-4.
2. Carefully remove the 3D model from the magnetic mat.
3. Put the magnetic mat back onto the print bed.
F-4
11 Filaments
11.1 Spare filaments
Purchase spare filaments that match the type (PCL or PLA) and are of the correct diameter. For details, see
Technical data ].
11.2 Switching filaments
To use a different filament you must first unload the filament that has already been fed through the extruder. You can
then load the new filament.
1. Before the feeder, clip the currently loaded filament with a side cutter.
2. In the mobile app, open Printer > Pre-heat.
3. Depending on your filament type (PCL/PLA), touch PCL Pre-heat or PLA Pre-heat in the mobile app to start
pre-heating.
The cooling fan runs.
Æ
The printer starts pre-heating. The current temperature shows in the mobile app.
Æ
4. In the mobile app, wait until the temperature shows X/X°C (example: 90/90°C), then touch Unloading to start
unloading the filament.
The feeder retracts the filament from the extruder.
Æ
5. As soon as all of the filament has been retracted, touch STOP in the mobile app to stop unloading.
6. Touch Stop Heating to stop pre-heating.
The cooling fan keeps running until the extruder is cool.
Æ
7. Load the new filament. Follow the instructions in
34
[ ►9.8 Loading filament
].
[ ►16
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
