Download Inhoudsopgave Inhoud Print deze pagina

Power2" Display For Effective Power, Output And Performance Factor; Consumption" Display For Overall Power Consumption - VOLTCRAFT Energy Logger 4000 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

In order to delete the MAX/MIN memory, keep the two „min" and „max" pressed simulta-
neously for approx. 2 seconds. The data is deleted if „MAX/MIN" appears on the display
simultaneously.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key
(7) for the previous display. Every time you press, you switch the display.
b) „Power2" display for effective power, output and performance factor
The „W" effective power displays the actually assumed load. The
effective power is established from the three parameters of current,
power and performance factor „cosPHI".
The „VA" outpur, however, establishes only the product from current
and power, which can result in a deviation from the effective power to
the outpur for capacity loads.
Your energy supplier always assumes the effective power as the basis for calculation (the
measurement device is not approved for balancing purposes!).
The MIN/MAX display is carried out as described in the „Power1" display.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key
(7) for the previous display. Every time you press, you switch the display.
c) „Consumption" display for overall power consumption
This display shows the entire, already used energy in kilowatt hours
and the thus calculated costs for tariffs 1 and 2.
Your energy supplier always states your energy
consumption and the tariff costs in kilowatt hours
(kWh) (The measuring device is not approved for
balancing purposes!).
In order to read the preset tariff values for tariffs 1 and 2, press the „max" key once. The display switches
back after approx. 5 seconds.
By pressing the „MODE" key for at least 3 sconds, all displays of „Consumption", „History",
„ON time" and „Forecast" are reset to nill, and the „MEM" memory deleted.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key
(7) for the previous display. Every time you press, you switch the display.
30

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

12 53 35

Inhoudsopgave